24 HOUR TRUCK REPAIRS(855) 450-1212 · Nights, weekends, holidays

Why are my trailer running lights and strobe lights not working when brake and turn signals work?

2026-11

Call (855) 450-1212Request help now

What was reported

["trailer running lights not working","trailer strobe lights not working","brake lights and signal lights working"]

Our answer

When a trailer's brake lights and turn signals work fine but the running lights and strobe lights fail to illuminate, the issue usually points to the specific tail and marker light circuit rather than a main ground failure. The most common cause is a loose, corroded, or damaged pin on the seven-way electrical cord or tractor receptacle, specifically the pin dedicated to the clearance and running light circuit. Another frequent culprit is a blown fuse or tripped circuit breaker in the tractor fuse panel powering the trailer marker light circuit. Wiring harness damage, such as a pinched or chaffed wire running along the trailer frame, or corrosion inside a junction box feeding the running and strobe light circuits can also cut power to those specific lights. As a driver, start by inspecting the seven-way plug and receptacle for green corrosion, bent pins, or loose fit. Try wiggling the cord while someone watches the lights, or swap in a spare seven-way cord if available. Next, check the tractor fuse box for any blown fuses corresponding to trailer clearance or tail lights. If the plug and fuses look good, a mobile technician will need to trace the wiring with a multimeter or circuit tester to locate open circuits, shorted wires, or bad connections along the trailer chassis.

What the technician found

Cause not confirmed on the call

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why won't my automatic truck start even though I have brand new batteries and tried jumpstarting it?

2026-11

When an automatic semi-truck refuses to start despite having brand-new batteries and a jumpstart attempt, the primary suspect is the starter motor or its control circuit. If your battery voltage reads 12.5 volts or higher, the batteries have sufficient charge…

What should I do if my diesel box truck runs out of fuel on the road?

Mercedes box truck · 2026-11

Running out of diesel in a box truck or commercial vehicle is a common issue that requires more than just pouring fuel into the tank. When a diesel engine runs completely dry, air enters the fuel lines, fuel filter housing, and injection system. Simply adding…

How do I fix a damaged box truck roof peak that is peeling up?

box truck · 2026-11

A peeling or damaged roof peak on a box truck is usually caused by impact with low-hanging tree branches, overhangs, or drive-thru awnings, though loose corner caps and deteriorated sealant can also allow wind to catch the front edge. Temporary fixes like duc…

Why won't my Kenworth start even though it has brand new batteries and no check engine light?

Kenworth · Culver, · 2026-11

When a Kenworth fails to crank or start despite having brand new batteries and no active fault codes on the dash, the electrical issue usually lies in the starter circuit, ignition system, or main grounding points. The most common culprit is a failed starter …

What should I do if I get a flat 11R22.5 tire on my semi truck on the highway?

2022 white truck · 2026-11

When experiencing a flat tire on a semi truck while on the highway, safety should be your immediate priority. Pull the vehicle as far onto the shoulder as safely possible, engage your hazard lights, and set out emergency warning triangles at proper distances …

All real calls

24 Hour Truck Repairs is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Call (855) 450-1212Request